Hoshizaki DBW-130H 130 lb Stainless Steel Hotel Ice and Water Dispenser
DBW-130H
Product overview
The Hoshizaki DBW-130H provides guest-operated ice and water dispensing for hotel and motel service areas. Its insulated, polyethylene-lined bin stores 130 lb of crescent cubes, and a push-button single-auger mechanism dispenses ice at approximately 20 lb per minute. A separate actuator arm dispenses water.
A compatible Hoshizaki modular crescent ice machine mounts above the dispenser and is purchased separately. Storage capacity and dispensing speed are not ice-production ratings; daily production depends on the selected ice machine.
- 130 lb storage: 3.7 cu. ft. measured volume.
- Approx. 20 lb/min: Push-button crescent-cube dispensing.
- 22-inch nominal width: Match the complete dispenser and ice-machine assembly.
Specifications
| Model | DBW-130H |
|---|---|
| Dispenser function | Ice And Water |
| Application ice storage capacity | 130 lb |
| Measured bin volume | 3.7 cu. ft. |
| Approximate dispensing rate | 20 lb/min |
| Dispensing gear motor | 60 W |
| Electrical supply | 115V / 60Hz / single phase |
| Rated current | 1.4 A |
| Minimum circuit ampacity | 15 A |
| Maximum fuse / breaker | 15 A |
| Electrical connection | Hardwired, independent grounded supply; power cord not included |
| Bin liner | Insulated polyethylene |
| Operating ambient | 45–100°F, indoors |
Ice-machine selection
The DBW-130H accommodates KM-322, KM-522 and KM-622 crescent-cuber families. Confirm the complete head model and required mounting or top-kit package before ordering; a DB ice-only combination does not establish DBW compatibility.
Installation and access
Install indoors on a firm, level foundation away from heat-producing equipment. Leave at least 6 inches at the rear, sides and top, with additional left-side access for drive-system service and any greater clearances required by the ice machine. Have a qualified installer level and securely fasten the complete assembly. Check the full installation drawing for the cabinet, projections, leg span and combined head height before preparing an opening.
The ice and water dispensing area is ADA compliant; preserve suitable access in the finished installation. A qualified electrician must provide an independent, grounded hardwired supply matched to the nameplate and applicable codes. If GFCI protection is required, use a GFCI breaker rather than a receptacle.
Plumbing
Run the dispenser drain separately from the ice machine and any water-cooled condenser drain. Use at least ¾-inch nominal-ID hard pipe or equivalent, a vented tee and a ¼-inch fall per horizontal foot. Maintain at least a 2-inch vertical air gap above the floor drain; do not pipe directly to the sewer.
Connect the water dispenser to potable water only, at 45–90°F and 10–113 PSIG. Its ½-inch FPT inlet requires at least ¼-inch nominal-ID copper tubing or equivalent and a shutoff valve. Install a pressure-reducing valve above 113 PSIG and resolve water hammer before installation. The separate ice machine has its own water-supply requirements.
Cleaning and service
Store only ice in the bin. Wipe the exterior monthly with a soft cloth and neutral cleaner as needed. Arrange qualified cleaning and sanitation of the dispenser and bin every six months, including the drain pans and clear drain lines. Inspect and lubricate the drive mechanism annually; shorten maintenance intervals when water quality, operating conditions or sanitation rules require it.
Service requires isolation and lockout of both dispenser and ice-machine power supplies. Do not bypass the front-panel interlock or ice-spout safety switch. Follow the complete cleaning and sanitizing procedure and chemical labels; do not use ammonia-type cleaners.
Warranty
Three-year limited parts-and-labor coverage applies to the dispenser, subject to proper installation, use, maintenance and the written terms. Register within 30 days of installation. Standard coverage applies in the United States, Canada, Puerto Rico and U.S. territories. Separate ice-machine compressor or evaporator extensions do not extend dispenser coverage. Review the complete warranty for exclusions and claim requirements.
Compare hotel dispensers
DB-130H: 130 lb, ice only · DB-200H: 200 lb, ice only · DBW-130H: 130 lb, ice and water. Each dispenser and its ice machine are sold separately; model-specific mounting and utility requirements apply.
Product documents
Hoshizaki DBW-130H 130 lb Stainless Steel Hotel Ice and Water Dispenser images
