Skip to content

Hoshizaki ER2A-FS Economy Series upright refrigerator with 38.61 cu. ft. capacity, 6 adjustable epoxy-coated shelves and two lockable stainless steel doors. Interior LED lighting, digital temperature display, automatic defrost and 4-inch casters. NEMA 5-15P plug with a 9-foot cord.

In Stock
Shipping calculated at checkout.

Product overview

The Hoshizaki ER2A-FS Economy Series upright refrigerator provides 38.61 cu. ft. of storage behind two lockable stainless steel doors. Its 6 gray epoxy-coated shelves adjust in ½-inch increments on aluminum supports, while interior LED lighting helps identify stored products.

A stainless steel interior floor is paired with aluminum sides, rear and top. The bottom-mounted refrigeration system uses R-290 refrigerant, automatic defrost and heated condensate removal. A digital controller displays temperature in Fahrenheit or Celsius and provides alarm indications. The doors are self-closing.

  • 38.61 cu. ft. capacity: 6 adjustable epoxy-coated shelves.
  • Lockable stainless steel doors: Self-closing access to packaged or bottled products.
  • Digital temperature display: Fahrenheit or Celsius display with alarm indications.

Specifications

Model ER2A-FS
Configuration Two sections, two solid doors
Interior capacity (AHAM) 38.61 cu. ft.
Included shelves 6 gray epoxy-coated shelves
Shelf size (W × D) 24.3 × 21.7 inches
Shelf adjustment ½-inch increments
Interior Stainless steel floor; aluminum sides, rear and top
Doors Self-closing stainless steel doors with locks
Casters 4-inch casters; two with brakes
Electrical supply 115V / 60Hz / single phase
HACR breaker 15 A
Plug and cord NEMA 5-15P; 9-foot cord
Refrigerant R-290
Defrost Time-initiated automatic defrost
Condensate removal Heated
Interior lighting LED
Cabinet depth 29.63 inches
Height including casters 81.63 inches

Storage and loading

Use the cabinet for packaged or bottled products, not chemicals or medical supplies. Leave space between products and interior surfaces, and keep the air inlet and outlet clear. Place products on properly installed shelves, supported at all four corners; do not place products on the cabinet floor or objects on top of the appliance.

Allow warm or hot products to cool before loading. At initial start-up, run the empty cabinet for two hours or three compressor on/off cycles and verify the temperature before adding stock. Avoid leaving doors open for long periods. Do not climb, stand or hang on the cabinet, doors or shelves.

Installation and electrical supply

Install indoors on a firm, level surface strong enough for the cabinet and its contents. Maintain at least 8 inches of clearance between the cabinet back and the wall, keep ventilation openings clear and protect the cabinet from direct sunlight. Confirm the delivered cabinet dimensions, door swing, room temperature requirements and service access before planning a close-fit installation. Move the cabinet upright and do not tilt it more than 45 degrees.

Have qualified personnel install the unit according to its instruction manual, nameplate and applicable codes. Use an independent, properly grounded three-prong outlet. Do not use an extension cord or adapter or remove the grounding prong. If GFCI protection is required, use a GFCI breaker rather than a GFCI receptacle. R-290 is flammable: keep ignition sources away, do not puncture refrigerant tubing or use mechanical defrosting tools, and leave refrigeration service to qualified technicians.

Cleaning and maintenance

Unplug the cabinet and move stored products to another refrigerator before cleaning. Clean the interior, exterior and shelves with a mild soap solution; avoid strong detergents. Do not spray, splash or pour water into the appliance. Wipe the interior dry and let the cabinet return to its setpoint before reloading.

Keep the lower-front condenser clean and arrange service when dust or grease accumulates. Follow the instruction manual’s cleaning procedure, with power disconnected. Keep the cabinet top and air passages unobstructed.

Additional shelves

Add HS-5512 epoxy-coated shelves for the two-section cabinet. Additional shelves are sold separately.

Limited warranty

Coverage for the original owner/user includes two years of parts and labor, with compressor-parts coverage continuing through year five; compressor labor after year two is excluded. Register within 30 days of installation. Coverage depends on proper installation, use and maintenance and applies in the United States, Canada, Puerto Rico and U.S. territories. Wear parts, improper installation and inadequate maintenance are excluded. Review the written warranty for complete terms and coverage outside these areas.

Compare Economy Series refrigerators

Choose the single-section or two-section cabinet for your storage requirements. Each unit is sold separately. ER1A-FS · ER2A-FS

Product documents